Barre d'outils maillage de navigation/fr

Cliquez sur dans la barre d'outils principale permet de basculer en mode d'édition maillage de navigation (affiche la barre d'outils Navmesh). Les boutons de la barre d'outils sont expliquées ci-dessous, mais assurez-vous de vérifier également l'antisèche.

• Select Triangles: Allows user to select Triangles in the navmesh.
• Select Vertices: Allows user to select Vertices in the navmesh.
• Select Edges: Allows user to select Edges in the navmesh.
• Standard View Mode: Navmesh is displayed normally.
• Transparent View Mode: Navmesh is displayed as transparent, making it easier to see the navmesh while editing.
• Navmesh Only View Mode: Hides everything except the navmesh. Useful for finding any errors in the navmesh.
• Test Pathing: Must be in Triangle Select Mode to use this. Tool used to test paths based on actor size.
• Balance for Optimization: Flips and creates edges that simplify the navmesh (useful for getting rid of "spider webbing"). Be sure to check your navmesh for errors afterwards, sometimes this command gives unwanted results.
• Find Cover Edges for Current Cell: Finds cover in all navmeshes in the loaded cell.
• Finalize Current Cell's Navmeshes: Finalizes loaded cell's navmeshes.
• Open Navmesh Generation Dialog:
• Open Advanced Navmesh Generation Dialog:
• Flood Fill: Select a triangle on a navmesh and click this icon to select all triangles in the navmesh.
• Inverse Flood Fill: Select a triangle on a navmesh and click this icon. All triangles NOT on the same navmesh as the selected triangle will be selected.
• Delete Selected Vertices/Triangles: Edges cannot be deleted, only vertices and triangles.
• Deselect:
• Cut Selected Object: Select an Object by holding CTRL-ALT and then Left Clicking on the object. Pressing this icon after a selection has been made will attempt to cut the navmesh around that object. Results may vary and it might be easier to navmesh around the object(s) by hand.
• Find Triangle: Brings up the Select Triangle by Index dialog.
• Create Triangle/Quad: Creates a triangle when three vertices are selected (or a quad if four vertices are selected).
• Drop Vertices: Drops selected vertices to the ground.
• Edge Rotate: Rotates a selected edge. Useful for when you want to change the shape of a triangle or get rid of "spider webbing".
• Edit Cover for Edge: Brings up the Edge Cover dialog only if the selected edge is on the edge of a navmesh. The dialog will not come up if the edge is found inside the navmesh because you cannot have cover on an internal edge.
• Merge Vertices: Merges selected vertices.
• Toggle Water: Select the triangles you want to set as water and press this icon. The triangles should change color.
• Toggle Preferred Pathing: Select the triangles you want to set as preferred and press this icon. The triangles should change color.

(Note: The following three icons are only active when navmeshing a base object, otherwise they're grayed out)

• Negative Box: Creates a box primitive attached to the base object's navmesh and cuts navmesh.
• Negative Sphere: Creates a sphere primitive attached to the base object's navmesh and cuts navmesh.
• Negative Plane: Creates a plane attached to the base object's navmesh and cuts navmesh.